How to change a sleeve
| 1. Heat the oven and remove any rubbers from the block. |
2. Place the block into the oven for about half an hour. |
| 3. Place the block onto a workbench, making the sleeve you are about
to remove is over the edge. |
|
| 4. Place a block of wood over the bottom of the sleave and using a
heavy hammer, knock the sleave out. |
|
| 4. Turn the block, and, again using the wooden block, hammer
the sleeve into position. |
Note: Make sure you have replaced the lower rubber sleeves, if they
have them. |
Note: If you've got a single or a V,
then it's easier to change the whole barrel, outer and sleeve. |
©