throttle

World of motorcycleS

Maintenance - cables

This is just a general guide.
If you are about to do your own maintenance, using these pages, I take no responsibility if you get things wrong!

1. Remove clamp, loosen the cable adjusters on the handlebar if it has them, undo the cable from the carburetta & remove cables from the throttle. (see throttle cables) 2. Pull the twist grip from the handlebar. and remove rust or dirt which might have accumilated over time. A wire brush and/or some emery paper will do the job.
	3. Grease the handlebar.
4. Clean the inside of the handle grip. An old toothbrush is ideal for this. 5. Replace the grip onto the handlebar and replace the cables back into position (see throttle cables for more info if needed)

Modified for 2009