S1 Publishing(Oxford)© 1999-06

World of motorcycleS
S1 Publishing(Oxford)© 1999-06
Engine Rebuild
Gilera Runner 125 FX
This is just a general guide.
If you are about to do your own maintenance, using these pages, I take no responsibility if you get things wrong!
Page 2
9. Place the base gasket into position
Gently ease the barrel into postion, use a couple of screwdrivers to close the compression rings. Note make sure that the ends of each ring aleigns with the two pins in the piston
10. Replace the rubber head gasket and place the head into position over the barrel 
11. Replace the four head nuts and torque them to correct settings
(10-11Nm)
12.Place the rubber gasket in the water jacket and place the jacket into position over the head. Replace the four bolts and tighten
13. replace the rubber tube and 3 way pipe. from the water jacket to the right hand crankcase
14. feed the starter motor lead through the hole of the right hand half of the crankcase and put th rubber in postion
15. repalce the stator plate into postion, use an impact driver and a little lock thread to the threads, to make sure they are not going to undo due to vibration.
16. Replace the genorator flywheel, making sure that the woodruff key fits into the grove provided..
17. Replace the pick ups and the wire run plate into position
Click here to go to page 3
Updated for 2009
Version 3 24-01-2017
©
Click on flaming logo to return to lobby area